Eaton HALO HOME HWAS1BLE40AWH Manual Del Usuario página 3

1
Removing the back panel
Press thumbs forward on the front of the
switch, near the top. The back panel should
slide down opposite the switch. Lift the back
panel off.
2
Once the back panel has been removed,
insert the 3 provided CR2032 Batteries
(Energizer Lithium recomended) in the
location shown with the "positive" side of
the battery facing you.
IMPORTANT: The red indicator light should
come on for about 1 second and go off. If the
light stays on permanently, it is necessary
to remove the batteries and reinstall them
again. The switch will not function if the light
is on permanently.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type.
WARNING: The battery (battery or batteries or battery pack) shall not be
exposed to excessive heat such as sunshine, fire or the like.
3