Eaton HALO HOME HWAS1BLE40AWH Manual Del Usuario página 4

3
Adding the switch to the APP
• Go to the HALO Home app.
• Press the " " menu button in the upper left and navigate to
"controllers" and the press the "+" button on the screen.
• Next, Press the button on the Switch so that the red light is flashing
a double flash.
- At this point you should see the switch appear on the screen.
• If the switch does not appear in the screen before the flashing light
goes off, then press the button on the switch again and repeat the
process.
• Select the switch and press "Done." It may take up to 30 seconds for
this process to complete.
Note: If the switch does not successfully add before the flashing light
goes off, then press the button on the switch again and repeat the
process.
• At that point the switch will be added and you will be ready to associate
it to a device.
4
Connect the switch to HALO Home devices
• If you want to associate to a single device, select the "Devices" tab
at the bottom.
- Swipe the device photos left or right until you find the device
you want.
• To associate to a group of devices, create a group if you have not
done so already. Then press the "Groups"
Note: You must create the group before you associate with the switch.
• Next swipe the group photos left or right until you find the group you
want.
4