Eaton HALO HOME HWAS1BLE40AWH Manual Del Usuario página 5

• If you like, you can give the switch a name and a photo by touching the
switch name or photo.
• Before your switch will work, it is necessary to save the configuration to
the switch. There are two steps to this process:
1) Hit "Save" in the upper right corner of the app screen.
2) Then, Press the button on the switch.
• Pressing the button on the switch is necessary because the switch
circuitry stays "asleep" unless someone is specifically touching it. This is
done to extend the battery life.
• You will know that the switch has properly saved when the app closes
the association screen and returns to the controller dashboard, and you
will also see the device or group name on the switch dashboard.
IMPORTANT: If you do not press the button on the switch and see the app
close the association screen, the changes will not be saved to the switch
and it will not work as expected.
Mounting by tape
Attach using the provided screws,
or to mount with tape: Find the side
of the tape marked "Wall side" and
make sure it is facing you.
Remove the opposite side of the
tape and stick to the area on the
switch marked "Tape". Push the tab
through the slot.
5