Setup Print Screen - Desoutter ESP-CA Serie Manual De Instrucciones

6159932380
Issue no: 05
5.3.7. PR CYCLE
In this field you have the choice between free
and fixed sequence of programs.
This parameter is valid for all 8 programs and
the modification of 1 of them affects all of the
Programs.
The PR CYCLE and SEQUENCE boxes are
linked: the Sequence Program Numbers
appears only if you select FIXED (see below).
PR CYCLE
1
FREE
Legend
1 PR CYCLE program
If you select FREE, you can choose the program
you need: manually and/or externally (EXT).
If you want to change the program manually
go to the SETUP SCREWDRIVER screen and
select PR 1..8.
If you want to change the program externally
go to the SETUP SCREWDRIVER screen and
select PR EXT.
Back to the main screen you will see the number
of the selected Program only after the choice
through pins 8...15 of the input connector
(through switchbox or PLC).
PR CYCLE
FIXED
1
Legend
1 PR CYCLE "FIXED" program
If you select FIXED, the second field
(SEQUENCE) appears with a series of 8
squares where you can set the sequence you
want.
Example:
2 3 6 _ _ _ _ _ automatically cycle 2, then 3,
then 6 and back to 2 again.
1 3 8 1 5 _ _ _ automatically cycle 1, then 3,
then 8, then 1, then 5, and back to 1 again.
EXT
1
PR ?
Cycle
Legend
1 "FIXED" with PR EXT program
12 / 296
SEQUENCE
_ _ _ _ _ _ _ _
SEQUENCE
2 3 6 _ _ _ _ _
EXT
1
PR 2
Cycle
If you select FIXED with PR EXT, the program to
choose will be forced. On the screen you will see
for example:
- The number of the program due will flash
until you choose it.
- The program continues with the cycle
sequence you have chosen, with the END
signal lit at the end of the sequence.

5.4. SETUP PRINT screen

To progress to the third screen, push MENU
again.
1
SETUP PRINT
DATE TIME
20/07/2009 01:15
PRINTED
DESCRIPTION
Legend
1 SETUP PRINT screen
- You can set date and hour.
5.4.1. PRINTED CYCLE
Different description for each cycle, max 15
letters.
It will be printed after each screw.
5.4.2. PRINTED DESCRIPTION
This is the description of max 50 letters on the
main screen.
It can be printed only on request after specific
input (pin 7) or at the beginning of each cycle (if
this option has been allowed).
5.4.3. SAVE DATA
The ESP CA unit allows to save each cycle data.
It's just necessary to insert the key in the USB
port, after a short audible sound, you can
proceed.
In the key, a new folder will be created: ESP CA.
In it, there will be another folder called like the
date set in the unit (year-month-day).
In this folder, every day you could save each
cycle done in .txt file.
Example:
11/03/09 09:43 PR1 P15 S 20% 320RPM 01/03
OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 02/03
OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 02/03
NOK TMIN Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 03/03
OK_ END_ Program 1
PR 1
PRINTED CYCLE
Program 1
05/2020