Areas Of Responsibility; Electromagnetic Compatibility (Emc); Fcc Statement (Applicable In U.s.) - Stanley TLM65 Manual De Instrucciones

Safety Instructions
EN

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Stanley Tools
701 E. Joppa Road
Towson, Maryland 21286
www.STANLEYLASERS.com
www.STANLEYTOOLS.com
www.STANLEYTOOLS.eu
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regula-
tions relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.
8
Electromagnetic Compatibility
(EMC)
WARNING
The device conforms to the most stringent
requirements of the relevant standards
and regulations.
However, the possibility of causing inter-
ference in other devices cannot be totally
excluded.
STANLEY TLM65

FCC statement (applicable in U.S.)

This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential instal-
lation.This equipment generates, uses and
can radiate radio frequency energy and, if
not installed and used in accordance with
the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that inter-
ference will not occur in a particular instal-
lation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the interfer-
ence by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.