Tabla de contenido
Publicidad
7
Getting started
This section explains how to connect Bode 100, put it into operation and how to perform the first
measurement with it.
7.1
Installing the Bode Analyzer Suite
To install the Bode Analyzer Suite insert the DVD delivered with the Bode 100 and follow the
instructions on the screen. In case that you have deactivated the auto run function of your computer's
operating system navigate to the root directory of the DVD and start the setup manually.
If you have no DVD drive on your computer you can download the latest version of the
Bode Analyzer Suite from www.omicron-lab.com.
It is recommended to disconnect the USB connection between the Bode 100 and your PC
during the installation of the Bode Analyzer Suite.
7.2
Powering the Bode 100
NOTICE
Equipment damage possible.
Make sure the voltage and polarity of the power supply match the ratings of the device.
► Use the power adapter delivered with the Bode 100.
The Bode 100 is powered with an external wide-range AC power adapter. Before powering Bode 100,
select the adapter's mains input plug fitting your power outlet. Plug the adapter's DC output connector
into the Bode 100 DC power input on the rear panel and the mains input plug into the power outlet.
7.3
Connecting Bode 100 to a computer
The Bode 100 communicates with the computer via USB. Connect the Bode 100's USB connector on
the rear panel to the USB connector of your computer using the USB cable delivered with your
Bode 100.
Some USB Hubs can cause problems with the data transfer between the Bode 100 and your
computer. In case you are experiencing problems with the USB connection, try to connect
your Bode 100 directly to a USB port of your computer. The same applies to some USB
isolators.
OMICRON Lab
Getting started
17
Publicidad
Tabla de contenido
