Stihl MS 192 T Manual De Instrucciones página 42

Machines with ElastoStart*
: Pry the cap out of the starter grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
starter grip and tie a simple
overhand knot.
: Pull the knot back into the grip.
: Refit the cap in the starter grip.
* Special option
MS 192 T, MS 192 TC
: Thread the rope through the top of
the guide bushing (5).
: Pull the starter rope through the
rotor and secure it with a simple
overhand knot.
English / USA
: Coat rope rotor bearing bore with
non-resinous oil.
: Slip rotor over starter post – turn it
back and forth to engage anchor
loop of rewind spring.
: Refit the pawl (4) in the rotor.
: Fit the washer (3) on the starter
post.
: Use screwdriver or suitable pliers to
install spring clip (2) on starter post
and engage it on the pawl's peg –
the spring clip must point clockwise
– see illustration.
41