Mounting The Bar And Chain - Stihl MS 192 T Manual De Instrucciones

The chainsaw should also be returned
immediately for maintenance whenever
the brake system cannot be thoroughly
cleaned or there is a change in its
operating characteristics.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of this manual.
The daily maintenance schedule for your
chainsaw set forth in your STIHL
owner's manual should be strictly
followed.
Store chainsaw in a dry and secure
place and away from children.
Before storing for longer than a few
days, always empty the fuel tank.
MS 192 T, MS 192 TC

Mounting the Bar and Chain

1
a
t = a : 2
You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see "Specifications"):
The chain pitch (1) must match the guide
bar. The drive link gauge (2) must match
the guide bar groove width (3).
The pitch is marked in inches on
the sprocket and guide bar (e.g. 3/8
or .325) and the groove width is
additionally marked on the bar in
millimeters (e.g. 1.6).
Do not run non-matching
components together (different
pitches or drive link gauges) since
they will otherwise be damaged
beyond repair within a very short
period of operation.
2
3
: Disengage the chain brake:
Pull the hand guard (4) toward
the handle.
6
: Unscrew the nut (5) and remove
the cover (6).
English / USA
4
5
21