Maintenance, Repair And Storage - Stihl MS 192 T Manual De Instrucciones

A
1
2
B
B
2
1
A
Cutting techniques:
– Cut straight through thin limbs.
– Support and secure heavy
branches with ropes.
– Limbs under strain create risk of
pinching! Always start relieving cut
(1) at compression side (A). Then
make bucking cut (2) at tension side
(B).
– If the saw pinches, stop the engine
and remove it from the limb.
If conditions allow, work from a lift
bucket.
MS 192 T, MS 192 TC
!
Warning!
Be extremely cautious when cutting
limbs under tension (spring poles). The
limbs could spring back toward the
operator and cause loss of control of the
saw and severe or fatal injury to the
operator. Only properly trained
professionals should work in an area
where the trees and limbs are tangled.
Working in blowdown areas is extremely
hazardous.
English / USA
MAINTENANCE, REPAIR AND
STORAGE
Maintenance, replacement, or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However if you claim
warranty for a component which has
not been serviced or maintained
properly or if nonapproved
replacement parts were used, STIHL
may deny warranty.
Never operate a chainsaw that is
damaged, improperly adjusted or not
completely or securely assembled.
Follow the maintenance and repair
instructions in the appropriate section of
your owner's manual, especially those in
the chapters "Mounting the bar and
chain", "Maintaining and Sharpening",
and "Chain Brake".
Only parts supplied or approved by
STIHL for the specific model are
authorided.
Although other parts may fit, their use, in
fact, may be extremely dangerous.
19