Specifications; Cutting Attachment - Stihl MS 192 T Manual De Instrucciones

Specifications

EPA / CEPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category:
A = 300 hours,
B = 125 hours,
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours,
Intermediate = 125 hours,
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
Displacement
Bore
Stroke
Idle speed
Max. chain speed
MS 192 T, MS 192 TC
Magneto ignition system
Electronic
Spark plug (suppressed)
NGK BPMR 7 A
Electrode gap
0.02 in (0.5 mm)
Carburetor
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity
0.57 US pt (0.27 l)
Fuel mix
see chapter on "Fuel"
Chain lubrication
Fully automatic, speed-controlled oil
pump with rotary piston
Oil tank capacity
0.46 US pt (0.22 l)
Dry weight MS 192 T
without cutting attachment:
6.6 lbs (3.0 kg)
Dry weight MS 192 TC
1.84 cu.in
without cutting attachment:
3
(30.1 cm )
7.10 lbs (3.2 kg)
1.46 in
(37 mm)
1.10 in

Cutting Attachment

(28 mm)
Recommended cutting attachments for
3,000 rpm
compliance with §5.11 of ANSI Standard
18.6 m/s
B 175.1-2000
(see page 14 of this Manual)
English / USA
STIHL reduced kickback bar
(with green label) for 3/8" P pitch:
- Picco Micro Mini,
groove width 0.043 in (1.1 mm)
- Picco Micro,
groove width 0.050 in (1.3 mm)
Rollomatic with sprocket nose
12, 14 or 16 in (30, 35 or 40 cm)
Rollomatic E Light with sprocket nose
14 in (35 cm)
1)
STIHL low kickback chain
(with green label) for 3/8" P pitch:
3/8" P (9.32 mm) Picco Micro Mini
(61 PMMC3, 61 PMN)
3/8" P (9.32 mm) Picco Micro Comfort 3
(63 PMC3)
Chain sprocket:
6-tooth for 3/8" Picco pitch
In order to comply with the kickback
performance requirements of § 5.11 of
ANSI Standard B 175.1-2000, do not
use replacement saw chain unless it has
been designated as meeting the ANSI
§ 5.11 requirements on this specific
powerhead, or has been designated as
1)
"low kickback" saw chain
accordance with the ANSI B 175.1-2000
standard.
Since new bar/chain combinations may
be developed after publication of this
manual, ask your STIHL dealer for the
latest recommendations.
1)
See definition of "low kickback
chain" on page 14 of this manual.
in
53