Schumacher Electric XI14 Manual Del Usuario página 5

3. CONNECTING INVERTER
The inverter and power source must be in the OFF mode.
power supply only.
Connecting inverter to a vehicle (100 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
Connecting inverter to 12v battery or 12v power source using
the Schumacher® SAC-103 12V outlet to battery clips adapter
(full inverter output):
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the positive (red) cable of the SAC-103 to the
power source positive (+) or battery terminal. Make sure the
connection is secure.
4. Connect the negative (black) cable of the SAC-103 to the
power source negative (-) or battery terminal. Make sure
the connection is secure.
5. Push the 12V power plug of the inverter firmly into the
outlet of the SAC-103.
6.
To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the
inverter is being connected to or disconnected from the 12-volt
power source.
blown fuses and permanent damage to the inverter.
4. OPERATING INSTRUCTIONS
1. Connect the inverter, as described in Section 3.
2. The LED indicator light should glow GREEN, verifying the
inverter is receiving power.
3. Make sure the device to be operated is turned OFF.
4.
Plug the device into the inverter AC outlet or USB port.
Make sure you connect your inverter to a 12-volt
Failure to make the correct connections will result in
• 4 •