Cosatto NITTY GRITTY GIGGLE 2 Manual Del Usuario página 6

Raincover
Seat unit
Harness
Bumper bar
Footmuff
Seat unit hood
Raincover
Child car seat
adaptor
Car seat mode
22- Fitting:
Removing is a reversal of this procedure.
23- Fitting:
Note: The seat unit can be fitted forward or rearward facing.
24- Removing:
25- Adjusting seat unit recline angle:
WARNING: Never adjust the seat unit with your child
in the seat.
26- Opening:
27- Closing:
28- Adjusting the strap length:
Slide the strap adjustor to suitable length (1, 2 & 3).
29- Adjusting the shoulder strap position:
30- Removing:
Push the shoulder strap retainer through the backrest (1).
Push the crotch strap retainer through the seat (2).
Rotate the "C" clip to expose its opening (3) and slide the waist strap out of the clip (4).
Refitting is a reversal of this procedure.
31- Fitting:
32- Opening:
33- Removing:
34- Fitting:
Open the harness 26 and remove chest pad & crotch pad (1).
Push the harness straps through the footmuff (2).
Attach the footmuff fabric fasteners to the rear of the backrest (3).
Refit chest pads & crotch pad then close the harness 27 .
35- Fitting:
36- Adjusting:
37- Removing:
38- Fitting:
39- Fitting:
Note: The child car seat adaptors are supplied with the "Giggle 2" TS.
The adaptors are handed. Dots are marked on the seat mounts and the adaptors (1).
These should be on the same side if fitted correctly.
40- Removing:
41- Note: The child car seat should only be fitted rearward facing.
42- Fitting:
43- Removing:
Press the memory release button (1). The button will stay depressed.
Press and hold the release button on the opposite side of the car seat (2).
Lift the child car seat off the chassis (3).