Cosatto nitty gritty supa dupa Manual Del Usuario página 7

Fabric bottle 28-
holder
Raincover 29-
Seat cover 30-
31-
32-
33-
34-
35-
36-
Pushchair 37-
Stand 38-
Fitting:
Fitting:
Removing:
Lift the lock cover (1) to reveal the release trigger and squeeze the trigger to lift
the locking mechanism upward (2).
Press down the secondary lock bar (3).
Release fabric fasteners at rear of backrest (1).
Rotate "C" clip to expose gap (1) and slide waist strap out (2).
Fold retainer flat (1) and push through slot in mounting block (2).
There are three retainers on each side of the pushchair. One on the front chassis
tubing (3) and two on the underside of the seat (4).
Disconnect double "D" ring strap under the calf support (1).
Slide seat cover off calf support end (1) and off the backrest tubing (2).
Prior to washing, unzip the top of the backrest section (1) and remove the three
backrest boards (2).
Refitting is a reversal of this procedure.
Closing:
Ensure both backrests are in the upright position 16 .
Always remove the raincover, placing it in the basket and close the hood
completely.
Lift the lock cover (1) to reveal the release trigger and squeeze the trigger to lift
the locking mechanism upward (2).
Press down the secondary lock bar (3).
Push the handles forward (4) until the auto locks engage (5).
The stand automatically unfolds when the pushchair is closed.
Note: To avoid injury ensure that your child is kept away when the pushchair is
used in free-standing mode.
Note: Any additional load attached to the pushchair will affect the stability of
the pushchair.