Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles wiring
harness located within the
driver's side frame rail at the
rear of the vehicle (Fig. 1). This
harness will contain connectors
similar to those on the
T-Connector harness.
3. Separate the vehicle connectors, taking care not to
damage the locking tabs. Inspect the connectors for dirt &
debris and clean if necessary.
4. Position the T-Connector harness between the
separated vehicle harness connectors. Press the
T-Connector ends firmly into the vehicle harness
connectors until they lock into place. Take care not to
damage the locking tabs.
5. Confirm correct operation with a test light or by using a
properly equipped trailer.
6. Position the 4-Flat trailer plug near the center of the
bumper within easy reach of the hitch and secure any loose
wires under the vehicle using the cable ties provided.
Fig. 1
Publicidad
