Pairing Your Jabra Sp200 With Your Mobile Phone - Jabra SP200 Manual Del Usuario

PAIRING YOUR JABRA SP200 WITH
YOUR MOBILE PHONE
the Speakerphone can be connected to a mobile phone using a
procedure called 'pairing' . by following a few simple steps, a phone
can be paired with the speakerphone in a matter of minutes .
1 Put the speakerphone in pairing mode
- When you turn on your Jabra SP200 for the first time, the
speakerphone will automatically start up in pairing mode – i .e .
it can be detected by your phone . When the speakerphone is in
pairing mode the blue LeD will flash rapidly .
2 Set your Bluetooth® phone to 'search' for the Jabra SP200
- Follow your phone's instruction guide . First make sure that
Bluetooth® is activated on your mobile phone . then set your
phone to search for devices . this usually involves going to a
'setup, ' 'connect' or 'Bluetooth®' menu on your phone and
selecting the option to 'search' or 'add' a Bluetooth® device .*
3 Your phone will find the Jabra SP200
- Your phone will find the speakerphone under the name "Jabra
SP200" . Your phone then asks if you want to pair with the
Jabra SP200 . accept by pressing 'Yes' or 'oK' on the phone and
confirm with the passkey or PIn = 0000 (4 zeros) . Your phone
will confirm when pairing is complete .
CONNECTIVITY
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
SELECT
Manual pairing mode
If you wish to use the speakerphone with a different phone, or
if the pairing process was interrupted, you can manually set the
speakerphone to pairing mode .
turn the speakerphone on . Press and hold the answer/end button
for approximately 5 seconds until the blue LeD light stars blinking
rapidly . then repeat steps 2 . and 3 . in the above pairing guide .
* Phone dependent
DEVICES FOUND
Jabra SP200
SELECT
Jabra SP200
Jabra SP200
Passkey:
****
OK
HANDSFREE
Jabra SP200
added.
The handsfree is
now ready for use
SELECT
6