Adjusting The Handle Height - Cosatto NITTY GRITTY CHA CHA Manual Del Usuario

operation
(see illustrations further on in this booklet)
1 - list of parts
Your pushchair is supplied in one carton and contains:
1. Pushchair (basket attached)
2. Hood
3. Footmuff
2 - opening the pushchair
To open the pushchair, first release the autolock which holds the pushchair in the umbrella
position by pushing down on the end of the autolock lever (a). Now holding the pushchair by its
handles, gently lower the front. To complete the operation, press hard on the pedal (b), until you
hear the 'click' from the secondary locking bar (c).
WARNING: Ensure that all locking devices are engaged before use.
3 - using the brake
To apply the brake, press either lever down firmly with your toe (a). Test the brake is engaged
correctly by trying to push the pushchair forwards for a short distance. To release the
brake, raise either of the levers (b).
NOTE: Always apply brake before loading or unloading a child from
the pushchair.
4 - using the front wheels
To allow the front wheels to swivel, push down on the locking lever as shown (a). To lock the
wheels into position lift the locking lever up (b) with the wheels in any position and run the
pushchair until you hear each wheel 'click' as they lock in position.

5 - adjusting the handle height

To raise the handles press the buttons (a) on the inside of each upper hinge. The handles will
automatically spring to a higher position.
To lower the handles press the buttons again (b) then push the handles down (c). Release the
buttons but keep pressing down on the handles until they lock in place.
6 - using the harness
A five point harness is provided to restrain your child. To unfasten push the button on the buckle
(a) and pull the clips clear.
To fasten the harness push the shoulder strap clips onto the waist strap clips (b) then push the
waist strap clips into the buckle until they lock in place (c).
Sliding adjusters are fitted on the shoulder straps (d), waist straps (e) and crotch strap (f).
The harness should be carefully adjusted so that it fits your child comfortably. To adjust to the
smallest size on the waist strap you will need to thread the adjusters through the "D" ring.
To adjust the shoulder strap height, unzip the liner on the back of the seat, locate the strap ends
(g) and pass through the slots, reposition to the desired height and pass the strap ends back
through relevant slot.
To remove the harness unzip the liner on the back of the seat, locate the strap ends (g) and
pass through the slots. Under the seat, pass the crotch strap end through its slot (h). On each side
of the seat feed the edge of the webbing through the opening in the 'C' clip (i). Push the 'C' clip
through the 'D' clip. The harness can now be removed from the seat.
Refitting the harness is a reversal of this procedure.
'D' rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
To remove or fit the chest pads unclip the buckle and remove the shoulder strap clips from the
waist strap clips and slide the chest pads on or off the straps.
WARNING: Always use the crotch strap in combination with the
waist belt.
4. Bumper bar
5. Raincover
6. Plastic drinks holder
7. Bundle bag