Basic Connections - Aspects LW109B Manual Del Usuario

Peruse the Instruction Book before connecting the player with other equipments.
Observe the color-coding when connecting audio and video cords
It is required that this unit be connected to a TV set in only one video output mode, and it be set
correspondingly, otherwise the picture quality might be affected.
A: Connecting to a TV set
1. TV set (optional)
2. DVD/VCD/CD player
3.4.5. Audio/ video cords (yellow, red, and
white) connected to AV sockets on TV
set (optional)
6. S-Video cable connected to a TV set
(optional)
7.8.9. Video cords (green, red, and blue) con-
nected to YUV input sockets on TV set
(optional).
10. AC power cord cable
B: Connecting to TV set with SCART jack
1. TV set (optional)
2. DVD/VCD /CD player
3. SCART cable connected to TV set
(optional)
4. AC power cord cable
Relevant settings:
If RGB input via the SCART jack is adopted,
please set "VIDEO OUTPUT " in "OSD setup
menu to "RGB".
If your TV set supports YUV (P-SCAN) input,
please set "VIDEO OUTPUT" in Video setup
menu to "P-SCAN".
If you use 2 CH output to a TV set or sound
equipments, please set "Center , Surround,
Subwoofer" output to "OFF".
Note:
Consumers should be well aware of that not the
YPbPr format of all TV sets is fully compatible
with that of this player! It is because the output
of this player is standard chromatic aberration
signal or RGB signal, and all TV sets that don't
adopt such criteria will possibly not be fully com-
patible with it. In that case, whenever there ap-
pear horizontal or vertical non-sync signal or
distorted pictures, set the VIDEO OUT mode in
OSD setup menu to S-VIDEO or Vid eo
(Component).

BASIC CONNECTIONS

A
B
- 68 -