Setup Operation; Figure 29 - Uline OHAUS AVIATOR 7000 Manual Del Usuario

SETUP OPERATION

ENTERING OPERATOR SETUP
1. Press and hold the MENU
(PLU) key until a long beep
can be heard.
SET 1 OP
is displayed for "Operator
Setup." (See Figure 29)
2. Press the ENTER (ON/OFF)
key to enter operator
configuration. The first
operator setup step and its
current setting are displayed.
NAVIGATION IN THE SETUP
SELECTING SETUP STEP
To move to another setup step,
use the ARROW DOWN (TARE )
key or ARROW UP (ZERO) key.
(See Figure 30)
In the line below, the
current setting of the step is
displayed.
CHANGING SETTINGS
To toggle between the
settings of a setup step, use
the ENTER (ON/OFF) key.
(See Figure 31)
When moving to another
setup step, the selected setting is confirmed.
OPERATOR SETUP OVERVIEW
Factory settings are indicated in bold print.
# SETTING
1 Reset
ON
OFF
2 Beeper
ON
OFF
PAGE 9 OF 39
OPERATOR SETUP

Figure 29

(press and hold)
SEt 1
StEP 01
Figure 30
StEP 01 StEP 02
StEP 05 StEP 04
Figure 31
ON OFF
0 1 2
DESCRIPTION
Reset operator setup functions to factory settings.
Do not reset operator setup functions.
Beep when a key is pressed.
No sound when a key is pressed.
ENDING SETUP
1. Press the MENU (PLU) key
to leave operator setup
steps. (See Figure 32)
2. Press the MENU (PLU) key
again to leave the setup
mode.
SAVE
OP
3. If you do not want to save,
use the ENTER (ON/OFF)
key to toggle between
OFF
and
SAVE
4. Press the MENU (PLU) key
a third time to return to the
weighing mode.
EXAMPLE: SETTING DIGITAL FILTER TO LOW
(Operator Setup Step 8)
1. Press and hold the MENU
(PLU ) key until a long beep
can be heard.
is displayed for "Operator
Setup." (See Figure 33)
2. Press the ENTER (ON/OFF )
key to enter operator
configuration. The first
operator setup step and
its current setting are
displayed.
ON
3. To move to setup step 8,
3
press the ARROW DOWN
(TARE) key repeatedly until
Step 08 with its current
setting is displayed.
4. To change the setting of setup step 8, press the
ENTER (ON/OFF) key repeatedly until the setting is
5. End setup by pressing the MENU (PLU ) key three
times.
Figure 32
is displayed.
SAVE
.
ABORT
Figure 33
SET 1 OP
SEt 1
OP
SAVE
ABORT
0.000
lb
(press and hold)
SEt 1
OP
StEP 01
OFF
StEP 08
...
2
StEP 08
...
0
0.000
lb
.
0
0721 IH-5116