Publicidad
Idiomas disponibles
Idiomas disponibles
1. Check that the kit includes all the parts listed in the first page.
Precautions
for
2. Check each part in the kit for scratches or any form of damage.
Installation
3. Park the vehicle on a level ground.
4. Remove the ignition key from the switch and store it in a safe place.
5. Disconnect the negative (–) cable from the battery.
6. Protect any items removed or to be installed from scratches by plac-
ing them on a soft cloth first before putting them on the ground.
7. Use care not to cause any damage to the body of the vehicle during
installation of the accessory.
Refer to the DL1050 service manual, when removing or installing
the STD part.
STD part = Part which is equipped with the vehicle as standard
part.
Tighten bolts to the torque indi-
Tightening
Torque
cated in the right table as standard
value unless otherwise explicitly
specified.
The value shows conventional or
"4" marked bolt tightening torque.
For other bolts not listed in the
table, refer to the service manual.
NOTICE
Diameter
(mm)
5
6
8
10
GENUINE SUZUKI ACCESSORIES
Tightening Torque
N·m
kgf-m
lbf-ft
3.0
0.3
2.0
5.5
0.55
4.0
13.0
1.3
9.5
29.0
2.9
21.0
3/6
Publicidad
