Power Connection; Getting Started - SOUNDMASTER high line FUR4000 Manual Del Usuario

INTRODUCTION
The unit is designed to automatically synchronize its current time and date with
radio signal generated from DCF 77 Frankfurt, Germany.

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit is equipped
with a battery back up system, it requires a 3V CR2032 flat lithium battery (not
included). Insert the battery in the battery compartment, making certain that the
positive and negative (+ and -) battery terminals are attached to the corresponding
terminals on the plate in the battery compartment. If an AC power failure occurs,
the clock automatically switches to the battery power supply, the clock and
timer memory continue running. When the AC power resumes, the clock
switches back to AC again.

GETTING STARTED

Press the reset button (20) locates on the bottom of unit after AC plug in.
- The unit will display full segment for 2 seconds, then it will enter the normal
mode.
- Display will lighten up.
- The unit will start searching RCC (RADIO CONTROLLED CLOCK) signal
automatically.
Display in searching mode
- Antenna tower icon will turn on and keep displaying.
- Wave icon will start blooming and keep changing by 0.5 second interval.
- Automatically stop after 10 minutes if fail in receiving.
Note : Auto search can be stopped by pressing snooze button (11) for 3
seconds.
Display in good reception mode
- Antenna tower icon and all wave icons will keep displaying.
ENGLISH
EN-2