Location Of Controls; Power Connection - SOUNDMASTER HighLine FUR 6000 Manual Del Usuario

LOCATION OF CONTROLS

1.
1. << BUTTON
2. ALARM 1 RADIO / BUZZ BUTTON
3. ALARM SET BUTTON
4. MODE BUTTON
5. >> / Y-M-D / DST BUTTON
6. SNOOZE / SLEEP BUTTON
7. ALARM 2 RADIO / BUZZ BUTTON
8. ON/OFF BUTTON
9. TUNE KNOB
10. VOLUME KNOB
11. AM/FM BAND BUTTON
12. LED DISPLAY
13. FM ANTENNA
14. AC POWER CORD
15. BATTERY DOOR
INTRODUCTION
THE UNIT IS DESIGNED TO AUTOMATICALLY SYNCHRONIZE ITS CURRENT
TIME AND DATE WITH RADIO SIGNAL GENERATED FROM DCF 77 FRANKFURT,
GERMANY.

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit is equipped with a
battery back up system, it requires a 3V CR2032 flat lithium battery (not included).
Insert the battery in the battery compartment, making certain that the positive and
negative (+ and -) battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the clock
automatically switches to the battery power supply, the clock and timer memory
continue running. When the AC power resumes, the clock switches back to AC again.
ENGLISH
16. RADIO CONTROLED CLOCK
ANTENNA
17. TYPENSCHILD
18. RESET BUTTON
19. LINE IN JACK
20. DISPLAY AUTO OFF / LOW / HIGH
DIMMER SWITCH
21. SPEAKER
22. FOCUS ADJUSTMENT FOR
PROJECTION UNIT
23. PROJECTION TIME 180° FLIP
BUTTON
24. PROJECTION ON/OFF BUTTON
25. PROJECTION UNIT
26. INFRARED SENSOR
ENG 2