Using The Manual Controls; Blending Tips - Oster OBL234X Manual De Instrucciones

5. To change your selection, press Stop followed by another Pre-Programmed
Setting button.
6. Once the program is finished the product automatically stops.
Please note: You may press the Start / Stop button to end the program at any time.
Press the Start / Stop button to start a new cycle from the beginning.
7. Press the power button to turn the product off.
This product is pre-programmed to turn off automatically if not used for a period of
several minutes. All lights will turn off when the unit automatically powers down.

USING THE MANUAL CONTROLS

The Manual Controls include:
• Speed "3" - High speed
• Speed "2" - Medium speed
• Speed "1" - Low speed
• Max Pulse - Pulse
• Low Pulse - Reverse Pulse
1. Press the power button to turn the product on. The power light
will illuminate, meaning the product is active and ready to use.
2. Put the ingredients into the jug.
3. Secure the lid and the jug lid cap.
USING THE MANUAL SPEED "1/2/3" BUTTONS
1. Press the "1/2/3" Speed button to run the product at a
low/medium/high speed.
2. Press the Start / Stop button to start the operation.
3. Press the Start / Stop button to pause the operation at any time.
4. Press the power button to turn the product off.
USING THE PULSE BUTTON
1. Press and hold the Pulse Button.
2. Release the pulse button to stop.
3. Press the power button to turn the product off.
USING THE REVERSE PULSE BUTTON
1. Press and hold the Reverse Pulse Button.
2. Release the pulse button to stop.
3. Press the power button to turn the product off.
6
OBL234X_20MLM1 (EMEA).indd 6-7 OBL234X_20MLM1 (EMEA).indd 6-7
CARING AND MAINTAINING YOUR OSTER BLENDER WITH REVERSIBLE MOTOR
AFTER USE:
1. Lift the jug from the base, remove the lid and empty the jug.
2. If necessary, use a rubber spatula to scrape foods away from the sides of the jar.
CLEANING
Release the Special 6-Point Blade with Jug Bottom, from the bottom of the jug by turning
the jug bottom counterclockwise.
The jug lid, jug lid cap and blade are dishwasher safe. Use the top rack of the dishwasher for the jug lid, jug
lid cap, and blade.
You can also wash the parts in warm, soapy water. Rinse well and dry. Wipe the base with a soft, damp cloth
to clean. Never submerge the low profile base in a liquid. Check the parts as you put them back together.
Reassemble the blender for storage. Leave the lid open a gap so no odors are retained.
WARNING: Never put the jug, or any other parts, in a microwave oven. Never store foods or
drinks in the jug.

BLENDING TIPS

Liquids
Put liquids into the jug first, unless the recipe says otherwise.
Using the jug lid food chute
Do not remove the lid while in use. Food may splatter if you do. Instead, open the jug lid cap to add smaller
ingredients.
Working with Hot Foods or Liquids
WARNING: When you work with HOT FOODS, remove the jug lid
food chute to vent steam. Tilt the lid away from you partially
covering the opening. Keep hands and other exposed skin away from
the lid opening to prevent possible burns.
When you work with HOT LIQUIDS, remove the jug lid food chute and
start at a low speed, and then gradually increase to a faster speed. Do
not add liquid over the cup (1L) level. Always keep hands away from
steam. Do not blend boiling liquids in the blender.
STORING
7
2/20/20 10:08 2/20/20 10:08