Symbols On The Device; Proper Use; Environment Protection - Kärcher BC 1/1.8 Manual De Instrucciones

Ocultar thumbs Ver también para BC 1/1.8:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

– Avoid contact with fluids oozing out of
defective battery packs. Rinse with wa-
ter in case of accidental contact with flu-
id. Consult a doctor if fluid comes into
contact with eyes.

Symbols on the device

– Protect the charger against moisture
and store it dry. The device is only suit-
able for use in rooms; do not expose the
device to rain.

Proper use

The charger is suitable for charging the fol-
lowing battery packs with nominal voltage
of 3.6 V to 28.8 V:
Voltage
V
Rechargea-
ble battery
type
Nominal ca-
Ah
pacity
Charging
min 50
time, approx.
Order
number

Environment protection

The packaging materials can be re-
cycled. Please do not throw the
packaging material into household
waste; please send it for recycling.
Old devices contain valuable mate-
rials that can be recycled; these
should be sent for recycling. Normal
and rechargeable batteries contain
materials that should not be directly
disposed off in nature. Please dis-
pose off old devices, batteries and
rechargeable batteries through suit-
able waste collection systems.
4
English
7.2
25.2
NiCd
Li-Ion
1.5
3.3
110
6.654-186 6.654-183
Operations
Note
New battery packs reach their full capacity
after approx. 5 charging and discharging
cycles.
Recharge battery packs again if they have
not been used for a long time.
The performance of the battery pack reduc-
es when temperature falls below –10 °C.
Storage for a long time at temperatures
above 40 °C can reduce the capacity of a
battery pack.
Insert the plug into the socket.
– The device conducts a self-test. Both
the LEDs glow for 1 second. The device
then goes into the stand-by mode: both
LEDs get switched off.
Slide the batter pack on the battery
holder of the charger.
– The battery pack will be charged auto-
matically; the green LED blinks.
– If the battery pack is too hot or too cold,
the red LED glows. The charging proc-
ess starts when the battery pack has
reached the correct charging tempera-
ture (5 °C ... 45 °C).
– When the battery pack is fully charged,
the green LED glows. The charger auto-
matically switches to retention charging.
Remove the battery pack and insert it in
the device.
Note
The charged battery pack can remain on
the charger till it is to be used. There is no
risk of over-charging.

Publicidad

Tabla de contenido
loading

Tabla de contenido