Triggering The Tacker - Prebena 1GP-A16 Manual Del Usuario

The driving depth of the fasteners depends on the hardness and
thickness of the wooden workpiece and the set operating pressure.
 Ensure that there are no persons behind the workpiece.
 Then check the operation of the tacker at a low operating
pressure by triggering it once.
 Regulate the operating pressure according to the resistance of
the wood used.
The correct operating pressure is set when the desired driving depth
of the fasteners is achieved at the lowest possible pressure.

Triggering the tacker

To trigger the tacker once, proceed as follows:
 Place the tool lug of the tacker on the wooden workpiece.
 Press the trigger (9).
A fastener is driven into the wood.
 Release the trigger.
 Lift the tacker off the wooden workpiece.
 Repeat these steps to drive in further fasteners.
Operating the tacker
21