Operating The Tacker; Regulating The Driving Depth Via Operating Pressure; Check Driving Depth - Prebena 1GP-A16 Manual Del Usuario

Operating the tacker

Regulating the driving depth via operating pressure

The driving depth of the fastener in the material can be set by
regulating the operating pressure. At a high operating pressure, the
fasteners are driven in deeper and not so deep at a lower operating
pressure.

Adjust the operating pressure so that the desired driving depth
is just reached. This offers the following advantages:
 You save energy (compressed air),
 You reduce the noise level, and
 You reduce the wear on the tacker.
To adjust the operating pressure, proceed as follows:
 Hold the tacker so that the tool lug faces down.
 Adjust the pressure at the pressure regulator of the compressor.
 Observe the pressure display of the compressor.

Check driving depth

 Press the tool lug onto a sample wooden workpiece with the
same properties as the material to be worked on.
 Check the setting by triggering once on the sample material.
 Repeat these steps until the desired driving depth is set.
Operating the tacker
19