Connecting Tacker To Compressed Air Supply - Prebena 1GP-A16 Manual Del Usuario

Preparing the tacker
-
No parts of the tacker or the accessories may show visible
signs of damage, such as scratches or dents.
Scratches on the housing paint or the magazine do not

constitute damage.
 Do not connect a damaged tacker to a compressed air supply.
 Have a damaged tacker repaired by qualified specialists before
putting it into operation.

Connecting tacker to compressed air supply

You can connect the tacker to a compressor or a compressed air
system.
Operation with a compressor or a compressed air system is only
permitted if the following preconditions are met:
 The operating pressure of the compressor or compressed air
system must not be more than 10% above the maximum
operating pressure of the tacker. Specifications on the operating
pressure of the tackers are provided in this chapter on page 14.
 On compressed air systems with higher pressure, a pressure
regulating valve (pressure reducer) with a downstream pressure
relief valve must be installed in the compressed air line.
 The compressed air must be filtered, dry and lubricated with
PREBENA special nailer oil.
 At the outlets for the compressed air line to the tacker, a
compressed air maintenance unit must be installed on the
coupling side. It should contain
-
a filter,
-
a water separator and
-
an oiler.
 If no oiler is installed, the length of the air line to the tacker must
not exceed 10 m. Otherwise three to five drops of PREBENA
special nailer oil must be filled directly into the air inlet of the
tacker every day prior to use.
 The compressed air system must be able to maintain operating
pressure even during the desired air removal.
 The inside diameter of the air line must be at least 6 mm.
 The connection for the tacker must be fitted with a quick-action
coupling, ID 7.2 and have an inside diameter of at least 6.5 mm.
14