Electric Connections - Kichler PINION 60 Manual De Instrucciones

ELECTRICAL CONNECTIONS
WARNING: To avoid possible electrical shock,be sure you have turned o the power
at the main circuit panel before wiring. Follow the steps below to connect the fan to
your household wiring. Use the wire connecting nuts supplied with your fan. Secure
the connector with electrical tape. Make sure there are no loose wire stands or connections.
WARNING: If your house wires are di erent colors than referenced in this manual,
stop immediately. A professional electrician is recommended to determine proper wiring.
Step 1. Insert the receiver into the mounting bracket, and keep flat in opposition of ceiling. (Fig. 15)
Step 2. Motor to Receiver Electrical Connections:
Connect the BLACK wire from the fan to BLACK wire marked "TO MOTOT L" from the receiver.
Connect the WHITE wire from the fan to the WHITE wire marked "TO MOTOR N" from the receiver.
Connect the BLUE wire from the fan to the BLUE wire marked "FOR LIGHT " from the receiver.
Connect the ORANGE wire from the fan to the ORANGE wire from the receiver.
Secure all the wire connections with the plastic wire nuts provided. ( Fig. 16)
Step 3. Remote Receiver to Outlet Box Electrical Connections:
Connect the BLACK (hot) wire from the ceiling to the BLACK wire marked "AC IN L" from the wall control .
Connect the WHITE (Neutral ) wire from the ceiling to the WHITE wire marked " AC IN N" from the receiver.
Connect the BLACK (To Motor L) wire from the wall control to the BLACK wire marked " AC IN L" from the receiver.
Secure the wire connections with the plastic wire connectors provided. (Fig. 16)
Step 4.
Connect GROUND (GREEN) wires from hanger ball and mounting bracket, so GROUND (GREEN or BARE COPPER ) from house.
Secure the wire connection w ith a plastic connectors provided. After connecting the wires, spread them apart so that the green and white
wires are on one side of the outlet box and black and blue wires are on the other side. (Fig. 16)
NOTE: Carefully tuck the wire connections up into the outlet box.
NOTE: Fan must be installed at a maximum distance of 30 feet from the transmitting unit for proper signal transmission between the
transmitting unit and t he fan's receiving unit.
10
Mounting Bracket
Receiver
Fig. 15