Electrical Connections - Kichler 300370 Manual De Instrucciones

ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock, be sure you have turned off the power
at the main circuit panel before wiring.
Follow the steps below to connect the fan to your household wiring. Use the wire
connectors supplied with your fan. Secure the connector with electrical tape. Make
sure there are no loose wire stands or connections. Receiver
Mounting Bracket
WARNING: If your house wires are different colors than referenced in this manual,
stop immediately. A professional electrician is recommended to determine proper
wiring.
Step 1. Insert the receiver into the mounting bracket, and keep flat in opposition of
ceiling. (Fig.13)
Step 2. Connect wires using the connectors as shown in WIRE DIAGRAM. (Fig.14)
WARNING: Check to see that all connections are tight, including ground, and that no
bare wire is visible at the wire connections.
Fig. 13
Step 3. After connections have been made, put the white and green leads (green or bare
copper) to one side and the black leads towards the other side, the connection should
be turned upward and carefully push leads into the outlet box. The wires should be
spread apart with the grounded conductor and the equipment-grounding conductor
on one side of the outlet box and the ungrounded conductor on the other side.
60" Rise | 11