Installation Of Safety Support; Electrical Connections - Kichler 330163 Manual De Instrucciones

INSTALLATION OF SAFETY SUPPORT

(Required for Canadian installation ONLY)
A safety support cable is provided to help prevent the ceiling fan
from falling, please install it as follows.
Step 1. Attach the provided wood screw to the ceiling joist next to the
mounting bracket. (Fig. 10)
Step 2. Adjust the length of the safety cable to reach the screw
by pulling the extra cable through the cable clamp until the overall
length is correct, put the end of the cable back through the cable
clamp, forming a loop at the end of the cable. Tighten the cable
clamp securely. Now, put the loop in the end of the safety cable over
the wood screw securely.
NOTE: Although the safety support cable is required for Canadian
installations only. It's a good idea to make the attachment with
any installation.

ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock, be sure you have
turned off the power at the main circuit panel.
Follow the steps below to connect the fan to your household wiring.
Use the wire connecting nuts supplied with your fan. Secure the
connector with electrical tape. Make sure there are no loose wire
strands or connections.
Step 1. Insert the receiver into the ceiling mounting bracket with the
flat side of the receiver facing the ceiling. (Fig. 11)
For best performance, make sure the black antenna, on the end
of the receiver, remains extended and not tangled with any of the
electrical wires.
Hanger bracket
Safety cable
Attach safety cable
to ceiling joist with
screw
Fig. 10
Receiver
Ceiling mounting
bracket
Fig. 11
11
52" Renew Designer |