Oster BVSTEM6601R Manual De Instrucciones página 12

AFTER PREPARING YOUR BEVERAGES WITH MILK
Once you are done preparing your beverage with milk, you can either store the unit's milk
reservoir directly in the refrigerator (ready to be used for the next time) or dispose of the
leftover milk.
C L EA N I NG YO UR AUTO M ATI C ESP R ESSO,
C A PP UCC INO, AN D L AT T E MA K ER
CLEANING THE MILK RESERVOIR AND FROTHING TUBE
Even though you can store the milk reservoir with left over milk in the refrigerator, it is
important to clean the reservoir and frothing tube regularly to avoid clogging and building
residues. In order to clean the milk reservoir, please follow the instructions listed below:
1. Remove the milk reservoir from the unit.
2. Remove the lid of the reservoir.
3. Pour any milk left and rinse and wash the milk reservoir and its lid thoroughly with warm
soapy water. Rinse and dry well. Do not use abrasive cleaners and scouring pads, as
they will scratch the finish. The milk reservoir is also dishwasher safe (top rack). Do not
place the lid of the milk reservoir on the dishwasher.
4. Place a large empty cup under the frothing tube.
5. Press and hold the clean "Limp" ( ) button for 3 seconds and then release it. The unit
will start releasing steam through the frothing tube, let it run for a few seconds until
you don't see any milk coming out of the tube. When done press the clean "Limp." ( )
button once to stop the process.
6. Dispose any water left on the milk reservoir and place it back in the unit.
CLEANING THE BREW HEAD, THE PORTA-FILTER AND FILTER
1. Switch the power button on the side of the unit to the off position "O" and unplug the
power cord from the electrical outlet.
2. Some of the metal parts might still be hot. Do not touch them with your hands until
they have cooled.
3. Remove the porta-filter and discard the coffee grounds or used pod. Wash both the
porta-filter and filter with warm soapy water and rinse them well. Do not wash the
porta-filter and filters in the dishwasher.
4. Wipe lower part of the brew head in the unit with a damp cloth or paper towel to
remove any coffee grounds that might have been left.
5. Place the porta-filter (without any filter) back in the brew head in the unit.
6. Place an empty large cup under the porta-filter.
7. Press the espresso "
stops automatically.
" button once and let the unit brew with water only until it
E ng lish-11