Oster BVSTEM6601R Manual De Instrucciones página 6

A P PLI ANC E fO R T h E fI R ST T I ME
CLEANING AND PRIMING THE UNIT PRIOR TO FIRST USE
Please refer to the "Description of the Appliance" section to familiarize with the
product and identify all parts.
1. Please make sure the unit is off "O" by pressing the on/off "I/O" button located on the
side of the unit. Make sure it is unplugged from the electrical outlet.
2. Remove stickers and labels from the unit.
3. First remove and then wash the water reservoir, the milk reservoir, the porta-filter, the
3 filters and measuring scoop in a mixture of mild detergent and water. Rinse each
thoroughly and place them back into the unit.
4. Refer to the instructions on "PLACING THE PORTA-FILTER" section before placing
or removing the porta-filter and filter from the unit.
5. To clean the inside of the appliance, follow the steps listed on the "PREPARING
CAPPUCCINO" section using water in both reservoirs and no coffee in the filter. Do
not immerse the appliance in water or attempt to reach any of its internal parts.
IMPORTANT - PRIME THE UNIT
To prime unit, run the steam cycle for 90 seconds by following the steps below:
1. Fill water reservoir between the "Min" and "Max" levels.
2. Fill the milk reservoir with water below the MAX level and slide the milk reservoir until
the 3 lights in the control panel illuminate.
3. Select one of the filters and place it on the porta-filter. Place the porta-filter in the unit
ensuring it is properly locked and place a cup under it. Also, make sure the tip of the
frothed milk dispensing tube is pointing inside the cup.
4. Plug the appliance into the appropriate outlet.
5. Turn the power button on "I".
6. The 3 control panel lights will start blinking. Once these lights become solid, press the
espresso button "
for up to 90 seconds.
7. Press the espresso button "
8. Press the cappuccino button"
water flow for up to 90 seconds.
9. Press the cappuccino button "
10. The 3 control panel lights will turn on solid indicating that the unit is ready to be used.
Now your unit has been primed and is ready to be used.
HOW TO SELECT THE RIGHT CUP
Please make sure to select your cup according to the following chart:
Espresso
Cappuccino
Latte
NOTE: the total amount of the beverage can vary depending on the type of milk used.
BEfO R E US I NG YO U R
" and hold it for 3 seconds, then release it. Let the water flow
" once again to stop the process.
" and hold it for 3 seconds, then release it. Let the
" once again to stop the process.
BEVERAGE
Single (
Double (
Single (
Double (
Single ( )
Double ( )
E ng lis h-5
SUGGESTED
CUP
)
40 ml
)
80 ml
)
180 ml
)
300 ml
350 ml
450 ml