BABYTREND HC07A Manual De Instrucciones página 3

WARNING
WARNING:
and the instructions could result in serious injury or
death.
FALL HAZARD:
severe head injuries including skull fractures when
falling from high chairs. Falls can happen suddenly if
child is not restrained properly.
• Always use restraints, and adjust to fit snugly.
• Tray is not designed to hold child in chair.
• Stay near and watch child during use.
• Never allow child to push away from table.
STRANGULATION HAZARD:
Do not place High Chair in any location in where there
are cords, such as a window blind cords, drapes,
phone cords etc.
WARNING:
the high chair at all times by the 5-point restraining
system, either in the reclining, semi-reclining or upright
position. The tray is not designed to hold the child
in the chair. It is recommended that the high chair be
used in the upright position only by children capable of
sitting upright unassisted. See page 10 for instructions
on proper use of restraint system.
• Other accessory items may change the balance of the high chair and cause
hazardous unstable conditions.
• Be certain the high chair is fully erect and latched in the open position before
allowing the child near the high chair.
• This high chair is designed to be used by a child with a maximum weight of 40
pounds, (18.14 kg.)
• NEVER allow your high chair to be used as a toy.
• NEVER use this product if there are any loose or missing fasteners, loose joints,
broken parts, or torn mesh/fabric. Check before assembly and periodically during
use. Contact Baby Trend Customer Service at 1-800-328-7363 for replacement
parts, repair or instructions. NEVER
3
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Failure to follow these warnings
Children have suffered
The child should be secured in
substitute parts.
IMPORTANT!
To ensure safe operation of your product, please
follow these instructions carefully. Please keep these instructions for
future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked in the
open position before using.
ATTENTION:
Carefully remove parts from box. Check that
you have all the parts for this model before
assembling the high chair.
NOTE: Certain High Chair models are
packaged with the High Chair Seat Fabric and
Seat Insert already attached to the Seat Back.
TO ASSEMBLE SEAT
1) • First locate the seat base. From the rear
of the seat base, remove the metal hinge
rod from the base (Fig. 1a).
• Press the latch down and slide the rod
out (Fig. 1b).
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Seat Back
Hinge Rod
Seat Base
Fig. 1a
Hinge rod retainer
Fig. 1b
4