BABYTREND HC07A Manual De Instrucciones página 6

ASSEMBLY
TO ATTACH TRAY
WARNING:
Always check
that the high chair is locked in
the open position before using.
WARNING:
The tray is
not designed to hold the child
in the chair. The child should
be secured in the high chair
at all times by the 5-point
restraining system, either in
the reclining, semi-reclining or
upright position.
10) • To attach the Tray, line up the grooves on
the bottom of the tray with the armrests of
the high chair. Squeeze the Tray's release
handle and slide the tray onto the armrests
(Fig. 10a). The Tray has a 3-position
adjustment. To adjust the position,
squeeze the Tray's release handle located
underneath the tray and reposition the tray
to the desired position (Fig. 10b). Release
the Tray's handle. Check that the Tray is
securely locked in its new position.
TO ATTACH TRAY INSERT
11) • The dishwasher safe food Tray Insert
snaps onto the High Chair Tray and is held
in place by tabs on the sides of the Tray.
When installing the Tray Insert make sure
that its snaps into place to prevent the child
from removing the Tray Insert. To remove
Insert, unsnap the tabs from the Tray.
• The Tray may be stored on the back legs
of the High Chair. Align the holes in the rear
of the tray with the small pegs on the back
legs (Fig. 11).
9
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Tray Release located underneath tray
Fig. 10a
3-position
Fig. 10b
Fig. 11
TO USE SAFETY BELT
WARNING:
It is recommended
that only children capable of sitting
upright unassisted use the high
chair in the upright position.
WARNING:
Prevent serious
injury or death from falls or sliding
out. Always use the restraint
system. The child should be
secured in the high chair at all
times by the 5-point restraining
system, either in the reclining,
semi-reclining or upright position.
12) • The shoulder straps of the 5-point harness have
2 attachment positions. Select the position that
places the shoulder strap level with, or below, the
top of the child's shoulders (Fig. 12a).
• Carefully place the child in the seat and position
the safety harness around the child's waist
and over the shoulders. Place the crotch strap
between the child's legs. Insert the male end of
each shoulder/waist belt into the buckle on the
crotch strap. Tighten the harness to be snug
around the child's waist and over the child's
shoulders (Fig. 12b).
TO RELEASE SAFETY BELT
13) • Push Button on Center Clasp, the two Harness
Buckles will pop free (Fig. 13).
RECLINE SEAT
14) • Squeeze recline lever on back of the seat and
adjust to the preferred recline or upright position
(Fig. 14).
Use caution not to trap arms, hands and fingers
when adjusting recline positions.
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 12a
Adjust for a snug fit
Fig. 12b
Center Clasp
Fig. 13
Fig. 14
10