Work And Safety Instructions - Festo 8111819 Descripción Resumida

Conjunto de сomponentes сircuitos básicos de la eléctrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5 Work and safety instructions

General
Trainees should work with the circuits only under the supervision of an instructor.
Electrical devices (e.g. power supply units, compressors and hydraulic power units) may only be
operated in training rooms that are equipped with residual current devices (RCD).
Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!
Malfunctions which might impair safety must not be generated when the device is operated for training
purposes.
Wear personal safety equipment (safety glasses, safety shoes) when working on circuits.
Mechanical safety
Switch off the power supply!
Switch off working and control power before working on the
circuit.
Do not reach into the setup unless it is at a complete standstill.
Be aware of potential overtravel times for the actuators.
Mount all of the components securely on the profile plate.
Make sure that limit switches are not actuated from the front.
Risk of injury during troubleshooting!
Use a tool such as a screwdriver to actuate limit switches.
Set all the components up in a way that makes it easy to activate the switches and interrupters.
Follow the instructions about positioning the components.
Electrical system
Risk of death in case of interrupted protective earth conductor!
The PE conductor (yellow-green) must not be interrupted, either inside or
outside of the device.
The insulation of the protective conductor must never be damaged or removed.
© Festo Didactic 8111817
DANGER
Component Set Basic Electrical Circuits
23

Publicidad

Tabla de contenido
loading

Tabla de contenido