Carrier 40VK005S-7S-QEE Manual De Instalación Y Propietario página 16

Installation Procedures
air outlet joint
right coupling
drain pipe
Fitting the Mounting Plate and Positioning the Wall Hole
(3) Lead the connection tubing (liquid pipe and gas pipe) through the hole into the wall, or connect piping and wiring
of the indoor unit, and then put the connection tubing and connecting line through from the inside wall
40VK005S-40VK012S
Pay attention to the following points before installation of machine:
1. Take out cushion blocks on the left and right-angle beads as
shown in the following Figure.
left coupling
A=95mm
heat insulating material
signal wire
drain pipe
electric connection of
indoor & outdoor units
40VK016S-40VK024S
40VK028S-40VK030S
16 9
tube
tube plate
A=125mm
A=140mm