Publicidad
Idiomas disponibles
Idiomas disponibles
33. Install top portion of underhood junction block, properly
securing locking retainers. Figure 13
FIGURE 13
34. Install junction block cover.
35. Route fog lamp harness branch with ring terminal ground
down along left side frame rail to ground location G300 (2).
Route fog lamp harness branch away from brake lines and
attach to chassis harness using tie straps. Figure 14
FIGURE 14
Fog Lamp Kit
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
36. Remove G300 ground bolt and install fog lamp harness ring
terminal along with chassis harness ring terminal.
37. Install G300 ground bolt.
Tighten 9 N·m (80 lb in)
38. Route lamp connector portion of the fog lamp harness along
side of the forward lamp harness forward through the lower
battery/ECM bracket, exiting below the radiator support.
Attach fog lamp harness to forward lamp harness using tie
straps. Figure 15
FIGURE 15
39. Route the short branch of wiring harness to left side fog
lamp opening. Install the conduit clip into lower radiator
support holes. Fog lamp conduit clips may need to be
adjusted to line up with radiator holes. Figure 16
FIGURE 16
PART NO.
IR 31JL07
INSTALLATION INSTRUCTIONS
DR
TITLE
PART NO.
19170448
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19170448
SHEET
Fog Lamp Kit
4
SHEET
4
15
OF
15
OF
Publicidad
