number 3 where the red wire was on the gas valve.
(see Figure 3-6)
Figure 3-6.
Wire gas pressure sensor (see Figure3-8)
8.
NOTE: Bottom right-hand connection is to earth-ground
(see Figure 3-7).
Figure 3-7.
Installation Addendum For 50 Hz Air-cooled Generators
Figure 3-8.
Connect a 5A fuse between Wire 8 and Wire 9.
9.
NOTE: Both wire ends need 18-20 AWG Male Fast-on
terminals (see Figure 3-9).
Figure 3-9.
Splice Wire 56 (from the starter relay) two (2)
10.
inches from connection. Add insulated connection,
and connect to the timer (see Figure 3-11).
NOTE: Do not pull wire out of relay. The solenoid con-
nection is very fragile.
Australia Fuel Field Install Kit
15