Timer Settings - Generac 0068570 Manual De Instalación

Australia Fuel Field Install Kit
Figure 3-1.
Figure 3-2.
Clip timer on to DIN rail (see Figure 3-3)
4.

Timer Settings:

• Top – timing dial (10 seconds, see inset Figure 3-3)
• Middle – fine time dial (.1)
•
Bottom – function dial (D)
1 10
10
1
1
10
1 - 10 s
10
ON
OFF
1
Figure 3-3.
Wire relays and timer per wiring diagram (see Fig-
5.
ure 3-4 and chart).
14
NOTE: Cover unused terminals with fast-on terminals.
Figure 3-4.
Wire to low oil pressure sensor and use convoluted
6.
tubing (wire goes from oil sensor, under the engine,
through the back of the engine divider panel, and
ends at the relays) (see Figure 3-5)
Figure 3-5.
Remove the red wire below and connect that to
7.
wire reference number 4. Connect wire reference
Installation Addendum For 50 Hz Air-cooled Generators