Replacing Bulbs - Faber Cylindra CYLN15SS600 Instrucciones De Instalación Información De Uso Y Cuidado

REPLACING ACTIVATED CHARCOAL FILTER
They cannot be washed or regenerated, and must be changed when led S1
starts to flash, or at least once every 4 months. The Alarm signal, if it has been
activated, only appears when the Hood Blower is turned on.
Resetting the Charcoal Filter Alarm
1. Turn the Lights and the Hood off.
2. Press
times in confirmation.
L T1 T2
Changing the Charcoal Filters
1. Open the Panel.
2. Remove the Filters one at a time, pushing them towards the back of
the unit and at the same time pulling downward.
3. Remove the saturated charcoal filter by releasing the fixing hooks.
4. Fit the new filter and fasten it in its correct position.
5. Replace, taking care to ensure that the handle faces forwards.
6. "When used in recirculation mode, to Reduce the Risk of Fire and
Shock use only conversion kit Model FILTER 2".
7. Close the Panel.

REPLACING BULBS

LED lights must be replaced by Faber factory authorized
service.
S1
and hold for at least 3 seconds, until LED flashes three
T3 T4
W
35