Clean The Machine; Lubricate The Blade; Store The Machine; Troubleshooting - GreenWorks HT24B05 Manual Del Operario

12.1

CLEAN THE MACHINE

WARNING
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
12.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
NOTE
We recommend to use the non-pollutant type oil.
13

STORE THE MACHINE

NOTE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
14

TROUBLESHOOTING

Problem Possible cause
The battery pack is
not installed tight-
The motor does
ly.
not start when you
pull the trigger.
The battery pack is
out of power.
The machine
The machine has
smokes during op-
damage.
eration.
English
Problem
The motor is on,
blades do not
move.
There is too much
noise and/or vibra-
tion during opera-
tion.
15
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Charger model
16
Solution
Make sure that
you tighlty install
the battery pack in
the machine.
Charge the battery
pack.
1. Immediately
Greenworks hereby warranties this product, to the original
stop the ma-
purchaser with proof of purchase, for a period of three (3)
chine.
years against defects in materials, parts or workmanship.
2. Remove the
Greenworks, at its own discretion, will repair or replace any
battery pack.
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
3. Contact the
units which have been used for personal use that have not
service center.
been hired or rented for industrial/commercial use, and that
9
Possible cause
The machine has
damage.
The blades are
blocked.
The parts are loos-
en.
The parts have
damage.

TECHNICAL DATA

24V
3000 (±10%) SPM
22 ''
18 mm
4.6 lbs
BAG711 and other BAG ser-
ies
CAG801 and other CAG ser-
ies

LIMITED WARRANTY

3
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
EN
Solution
Do not use the ma-
chine and contact
the service center.
Remove battery
pack then clear
blockage from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
chine and contact
the service center.