Pivoting Head Function; Maintenance; General Information; Clean The Machine - GreenWorks 21332 Manual Del Operador

EN

9.10 PIVOTING HEAD FUNCTION

Adjust pivoting head to trim areas which are hard to
reach and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until
the trimmer head locks into required position.
3. Release the pivoting button (14).
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
Use only the replacement parts and accessories of the
initial manufacturer.

10.1 GENERAL INFORMATION

Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English

10.2 CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.

10.3 REPLACE THE SPOOL

1. Push the tabs (18) on the sides of the trimmer head
at the same time.
2. Pull and remove the spool cover (19).
3. Remove the remaining spool.
4. Put the new spool (20) in the spool housing (21).
Make sure that you put the cutting line in the slot on
the new spool and extend the line approximately 15
cm before you install the new spool.
5. Put the ends of the cutting lines through the holes
(22).
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
10
NOTE