Operation - Husky H301PL Manual Del Operador

WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
DANGER:
Do not disassemble check valve, tank drain valves or
safety relief valve with air in tank — bleed tank.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
WARNING:
This equipment incorporates parts, such as snap
switches, receptacles, and the like that tend to produce
arcs or sparks and, therefore, when located in a garage,
it should be in a room or enclosure provided for the
purpose, or should be 18 in. (457 mm) or more above
the floor.
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
All manuals and user guides at all-guides.com
ASSEMBLY

OPERATION

APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this product for the purposes listed below:
 Operating some air-powered tools
 Operating air accessories such as air nozzles and
TRANSPORTING THE AIR COMPRESSOR
See Figure 3 - 4, page 18.
The air compressor should be moved as shown in figure 4.
This will help you to avoid damaging the wheels or the air
compressor by rolling it over items in its path.
To move the air compressor:
 Ensure AUTO/OFF switch is in the OFF position and the
NOTE: To reduce the risk of tripping secure the 25-ft hose to
the clip located outside the integrated coil hose retainer and
make sure the power cord is secured in the cord wrap.
 Pull the folding handle out
 Facing the back of the air compressor, grasp the folding
 Lift the air compressor toward you until it balances on
11 - English
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
CAUTION:
Do not use in an environment that is dusty or otherwise
contaminated. Using the air compressor in this type of
environment may cause damage to the unit.
inflators
air compressor is unplugged.
handle firmly with one hand.
the wheels.