Maintenance And Cleaning - FALMEC CIELO IS 120 Manual De Instrucciones

G
METAL FILTERS AND CARBON FILTERS
1. METAL FILTERS
To access the metal filters open the panel P (see fig. G1).
To remove the grease-trapping metal filter, use handle "A" (see figure G1 – detail 1-2).
2. CARBON-ZEO FILTERS
To replace the 4 carbon-zeo filters see fig. G2. The filters are fixed to the hood body using
magnets.
Replacement code of the complete kit of carbon-zeo filters (4 filters type A + 2 filters type
B): KCL.932.
To order new carbon zeo filters contact your distributor/dealer.
ONLY FOR ITALY: Download the specific filter order form from www.falmec.com (access the
drop-down assistance menu).
H
LIGHTING
The range hood is equipped with high efficiency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions. The LED lamp must be replaced only by
qualified technicians using only original spare parts.
I

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. GREASE-TRAPPING METAL FILTER
They retain suspended grease particles; therefore, we recommend
washing them in hot water, paying attention not to bend them. Wait for them to dry com-
pletely before remounting them. For assembly and disassembly instructions, see section
G1. We recommend performing this operation with regularly.
2. CARBON ZEO FILTERS
The CARBON.ZEO filters do not require special maintenance. In normal conditions, we
recommend restoring them every 18 months and replace them every 3 years. Before start-
ing any operation, disconnect the cookerhood from the power supply. To remove the filters
see paragraph H2.
To restore the CARBON.ZEO filter (every 18 months), place it into a normal domestic oven
at a temperature of 200° for about 2 hours. Once the filter has cooled down, remount the
filters (4 type A filters + 2 type B filters) on the hood as indicated in section G2.
Reconnect the hood to the power supply
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid
that oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using
ASSEMBLY AND REPLACEMENT
19