Maintenance And Cleaning; Metal Grease-Trapping Filters; Cleaning The Inside Of The Appliance - FALMEC MOVE 120 Manual De Instrucciones

I
LIGHTING
LED LAMP
In this case the hood is equipped with high efficiency, low consumption LED lamp with ex-
tremely long duration under normal use conditions.
L
MAINTENANCE
Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CARBON ZEO FILTERS
The CARBON.ZEO filters do not require special maintenance. In normal conditions, we
recommend restoring them every 18 months and replace them every 3 years. Before start-
ing any operation, disconnect the cookerhood from the power supply. To remove the filters
see paragraph H2.
To restore the CARBON.ZEO filter (every 18 months), place it into a normal domestic oven
at a temperature of 200° for about 2 hours. Once the filter has cooled down, remount the
CARBON ZEO filter following the inverse procedure described in point H2.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid
that oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using
abrasive substances or rough cloths will inevitably damage the finish of steel. The steel
surface will be irrevocably damaged if the instructions above are not complied with. Keep
these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the
instructions above.

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be
cleaned using liquids or solvents.
Do not use abrasive products.
All the above operations must be performed after having disconnected the appliance from the
mains power supply.
20
AND CLEANING