Fein WSG 20-180 Manual De Instrucciones página 10

WSG 20-180/230 - Buch Seite 10 Donnerstag, 1. Februar 2001 4:21 16
EN
Operating instructions for angle grinder.
Overview.
1 Switch
Switching ON/OFF (a),
Switch safety lock (b).
2 Locking button
Lock the drive when changing the tool.
3 Threaded flange
Secure or change the grinding tool.
4 Clamping lever (c) for protective
guard (e)
Mount the protective guard and adjust.
5 Auxiliary handle
For mounting on the left or right of the
power tool.
6 Adjustable machine handle
4 possible handle positions.
7 Supplied accessories
Protective guard (e).
Auxiliary handle (f).
Threaded and inner flange (g).
Face spanner (h).
For your safety.
Before using this power tool,
read and comply with:
these operating instructions,
the enclosed safety instructions
(document number 3 41 30 054 06 1),
the relevant national industrial safety
regulations.
These operating instructions and the
enclosed safety information should be
kept carefully for later use and enclosed
with the machine, should it be passed on
or sold.
10
WSG 20-180 / WSG 20-230
Intended use.
This power tool is intended for:
commercial use in industry and trade,
cut-off grinding and surface grinding metal
and stone – dry grinding –
for applications using the grinding tool and
accessories stipulated in these operating
instructions or recommended by FEIN.
Only cut stone using the guide
block (accessory) and protective guard.
When working with metal, conductive
dust may accumulate inside the power
tool. When this is the case, blow out the
motor space frequently from outside
using dry compressed air, work using the
dust extraction facility and operate the
power tool using an RCD switch (actuat-
ing current 30 mA).
Safety instructions.
!
Risk of injury
Only use grinding tools according to
EN 68 – approved for peripheral veloci-
ties of up to 80 m/s (marked by a red
stripe), combined plastic and fibre-rein-
forced; observe expiration date.
Chain mortising discs and saw blades are
not approved.
Only use grinding tools with a permissible
speed equivalent to at least the no-load
speed of the power tool.
Examine the grinding tools before use.
Only use undamaged grinding tools.
The bore of the grinding tool must fit onto
the carrier of the power tool without any
play. Do not use any reducers or adapters.
The mounted grinding tool must be able
to rotate freely.