After Use; Maintenance Schedule; Servicing The Vacuum Motors; Important - Nilfisk-Advance Adphibian Instrucciones De Uso

A-18 / ENGLISH

AFTER USE

1 Press the red Scrub OFF Switch (H) to raise the brushes. Raise the squeegee and move the machine to a service area.
2 Turn the Master Key Switch (A) OFF and remove the key.
3 To empty the solution tank, pull the Solution Drain Hose (22) off the elbow. Direct the hose to a fl oor drain or bucket. Rinse the tank with clean water. Inspect
the solution hoses; replace if kinked or damaged.
4 To empty the recovery tank, remove the Recovery Tank Drain Hose (25) from its hanger, then remove the cap (hold the end of the hose above the water level
in the tank to avoid sudden, uncontrolled fl ow of waste water). The Recovery Tank Drain Hose (25) can be squeezed to regulate the fl ow. Rinse the tank and
recovery tank switch (34) with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged. SERVICE NOTE: Make sure you do not
get any water down the Vacuum Motor Inlet Screens (12) while cleaning.
5 Remove the brushes then rinse them with warm water and remove any built up string, hair or carpet fi bers. Hang the brushes up to dry.
6 Remove the squeegee, rinse it with warm water and hang it up to dry.
7 Check the maintenance schedule below and perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Check/Clean Tanks and Hoses (clean recovery tank switch & vacuum inlet screens)
Check Each Battery Cell(s) Water Level (does not apply to gel cell batteries)
* Have Nilfi sk-Advance check the vacuum motors' carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes
check every 500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
8 Store the machine in a clean, dry place.
9 Turn the Master Key Switch (A) OFF (O) and remove the key.

SERVICING THE VACUUM MOTORS

Have your Nilfi sk-Advance Dealer check the carbon motors brushes once a year or after 300 operating hours.

IMPORTANT!

Motor damage resulting from failure to
service the carbon brushes is not covered
under warranty. See the Limited Warranty
Statement.

LUBRICATING THE MACHINE

See Figure 5. Once a month lubricate the pivot points
below. For best results, use a spray silicone lubricant.
• General Pivot Points For the Brush Linkage (A).
• General Pivot Points for the Squeegee Linkage (B).
• Squeegee mount angle adjustment knob threads
(C).
• Squeegee Tool end wheels (D).
• Scrub deck bumper wheels.
Once per quarter, Grease the following. Wipe off any
excess grease to avoid staining carpet.
• Rear Caster Wheel Swivel (E).
A-18 - 56041711 - Adphibian
MAINTENANCE ITEM
Check/Clean/Rotate the Brushes
Check/Clean the Squeegee
Empty and Clean Debris Hopper
Clean Vacuum Shoes
Inspect and Clean Solution Filter
Clean Solution Spray Nozzles
Purge Detergent System
Lubricate the Machine
* Check Carbon Brushes
/ AX 651 Combi EDS
™
Daily Weekly
Charge Batteries X
X
X
X
X
X
X
X
X
X
FIGURE 5
Monthly Yearly
X
X