After Use; Maintenance Schedule; Lubricating The Machine - Nilfisk-Advance Advenger 2800ST Instrucciones De Uso

A-16 / ENGLISH

AFTER USE

1 When fi nished scrubbing, press the Scrub ON/OFF Switch (H), this will automatically raise, retract and stop all the machine systems (brush, squeegee,
vacuum, solution and detergent (AXP models)) (Advenger models) or manually raise the scrub deck and squeegee. Then drive the machine to a service
area for daily maintenance and review of other needed service up keep.
2 To empty the solution tank;
Advenger models: Remove the Solution Drain Hose (2) from its storage clamp. Direct the hose to a designated "DISPOSAL SITE" and remove the plug.
Rinse the tank with clean water.
ST models: Drive the machine over a designated "DISPOSAL SITE". Close the Solution Shutoff Valve (21). Remove the Solution Filter (40) and then slowly
open the shutoff valve. Rinse the tank with clean water.
3 To empty the recovery tank, pull the Recovery Tank Drain Hose (31) from its storage area. Direct the hose to a designated "DISPOSAL SITE" and unscrew
the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). Rinse the tank with clean water.
4 Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
5 Remove the squeegee and rinse it with warm water. Open the Recovery tank cover and hang the squeegee from the recovery tank using the Squeegee
Storage Hook (30).
6 Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by removing the skirt and tilting the hopper up and
away from housing, then pull out.
7 Check the maintenance schedule below and perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Check/Clean the vacuum motor foam fi lter(s)
Empty/Clean Strainer Basket in Recovery Tank
Clean Solution Trough on Cylindrical System
* Have Advance check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every
500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.
8 Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
9 Turn the Master Key Switch (A) OFF (O) and remove the key.

LUBRICATING THE MACHINE

Once a month, apply light machine oil to lubricate the:
• Steering Chain
• General Pivot Points For the Squeegee and Scrub Deck Linkage
• Side Skirt Height Adjustment Knobs
• Steering Wheel Shaft Universal joint
• Front Roller Bumper
A-16 - FORM NO. 56041735 - Advenger
MAINTENANCE ITEM
Charge Batteries
Check/Clean Tanks & Hoses
Check/Clean/Rotate the Brushes/Pads
Check/Clean the Squeegee
Check/Clean Vacuum Shut-Off Float
Clean Hopper on Cylindrical System
Check Each Battery Cell(s) Water Level
Inspect Scrub Housing Skirts
Inspect and clean Solution Filter
Purge Detergent System (AXP only)
Lubrication of Machine
* Check Carbon Brushes
™
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Yearly
X