Assembly Instructions; Scope Of Delivery; Fitting The Wheels; Mount The Control Element - Grizzly Tools EGT 1440 Traducción Del Manual De Instrucciones Original

Assembly instructions

Always disconnect the tool from the
mains before conducting any work on it.

Scope of delivery

Carefully remove the tool from the pack-
aging and check that the following parts
are complete:
- Motor housing with cutting blade and
control element
- Upper grip handle
- Middle handle bar
- Mounting accessories for handle mounting
(4 tightening levers, 4 washers, 4 screws)
- 2 wheels
- Mounting accessories for wheel
mounting
(2 hubcaps, 2 screws, 2 washers,
2 spring washers)
- 2 cable clamps
- Translation of the original instructions
for use

Fitting the wheels

1. Put a wheel (14) on the wheel
axle (14a) so that the hub cap is
facing outwards.
2. Screw the wheel (14) on to
the device. To do this, use the
enclosed screw (14c), spring
washer (14d) and standard
washer (14e).
3. Press the end cap (14b) on the
wheel.
4. Mount the second wheel in the
same way.

Mount the control element

1. If necessary, loosen the 4
screws (1a) on the control ele-
ment (1) and remove the handle
cover (1b).
2. Press the end of the upper han-
dle bar (6) into the control ele-
ment (1) so that the holes in the
upper handle bar fit into the pins
on the control element (1).
Make sure that the cable of the
device (18) is not twisted.
3. Put on the handle bar cover
(1b) and screw it tight with the
4 screws (1a).

Mounting the grip rod

Make sure during assembly that
the device cable is not pinched
and has enough play.
Mounting the middle handle
bar:
1. Position the curved end of the
middle handle bar (9) between
the lower handle bar (11).
2. Attach the middle handle bar with
the screws (10), washers (10b)
and clamping levers (10) supplied.
3. Turn the tightening levers (10)
clockwise.
4. Lock the tightening levers (10)
by pressing them in the direc-
tion of the middle handle (9).
The tightening levers must be
positioned against the handle
such that tightening can be car-
ried out with medium force.
If this fails, continue to turn
the tightening lever clockwise,
or loosen it by turning counter
clockwise (see small image).
GB
73