Sinbo SHC 4355 Guia De Inicio Rapido página 9

How to use the shaver head
Turn the switch with "OFF" to charge, after full charging then turn switch with "ON" for using.
Guide the shaver head near the face or body, and moving unit up and down for cutting.
There with 2mm & 4mm attachment comb for your free choice pleased do not press unit with so strong
force, if not it will hurt the user.
After using
Clean the unit after every use and keep switch with off status to maintain optimal
performance.
When charging
Please don't charge if the temperature is lower than 0 or higher than 40.
Please don't charge if it is nearby the sunlight perpendicular incidence or the heat source radiates.
The standard charging time is 8 hours. In order to avoid damaging the batteries, please don't extend
the charging time.
Caution
Cleaning the housing using only a cloth slightly dampened water or a mild soap solution.
Never use a caustic solution.
Never submerge the clipper in water.
Keep away from the children.
This clipper may become warm during operating and/or charging, this is normal.
Handing the clipper but not hold the power soft line, avoiding disconnecting to damage the machine.
Never tamper with moving parts.
This appliance is not intended for use by persons(including children) with reduced physical, sensory
of mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety;
Children should be supervised to ensure that they do not play with the appliance.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Not to be used in bath or shower
WARNING: Keep the appliance dry.
Technical Data:
Charging Time: 8 Hours
Operation Time: 45 Minutes (When fully loaded)
Adaptor Input: AC 100-240V,50/60Hz
Adaptor Output: 3VDC, 150mA
- 8 -