Mechanical Installation; Prepare The Sampler - Hach AS950 Manual Del Usuario

Ocultar thumbs Ver también para AS950:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 104
• For limitations on transport velocity and maximum vertical lift, refer to

5.3 Mechanical installation

5.3.1 Install the sampler in a manhole
Install the sampler above the sample water in a manhole. Install the sampler with a spanner bar or a
support bracket. Install the spanner bar inside the manhole. The spanner bar is supported by
pressure against the walls. The support bracket has the same width as the manhole cover. Install the
support bracket directly below the cover for support. For the accessories, refer to the expanded
manual on the manufacturer's website. Refer to the documentation supplied with the accessories to
install the sampler.

5.4 Prepare the sampler

5.4.1 Clean the sample bottles
Clean the sample bottles and caps with a brush, water and a mild detergent. Flush the sample
bottles with fresh water followed by a distilled water rinse.
5.4.2 Install a single bottle
When a single bottle is used to collect one composite sample, do the steps that follow. When multiple
bottles are used, refer to
When the bottle is full, the full bottle shut-off stops the sample program. Install the sample bottle as
shown in
Figure
4.
Figure 4 Single bottle installation
1 Polyethylene bottle, 10 L (2.6 gal)
2 Glass bottle, 10 L (2.6 gal)
3 Support for standard base and 10 L (2.6 gal)
glass bottle
4 Polyethylene bottle, 15 L (4 gal)
5 Polyethylene bottle, 19 L (5 gal)
5.4.3 Install the first bottle for multiple sample collections
Use multiple bottles to collect samples into separate bottles or into more than one bottle. The
distributor moves the sample tube above each bottle. Install the bottles in the sampler base as shown
in
Figure
5. Install the first sample bottle (number 1) below the label in the sampler base. Install the
Install the first bottle for multiple sample collections
Specifications
6 Polyethylene bottle, 21 L (5.5 gal)
7 Compact base
8 Standard insulated base
9 Composite insulated base for 21 L (5.5 gal)
bottle
on page 3.
on page 11.
English 11

Publicidad

Tabla de contenido
loading

Tabla de contenido